I found the LG command codes here (PDF) (link is now dead as of Dec 2019, try this ). In putty, I left “flow control” at the default XON/XOFF option. Specifically, that means 9600 baud, 8 data bits, no parity bit, and 1 stop bit. The common “9600 8N1” settings did the trick. I opened up putty and configured it based on a little googling. I opened the device manager to find out which COM port was assigned to the adapter (it was COM3 – typical). My laptop is running Windows 10 and luckily the USB-serial adapter is truly plug and play. My wife (who is much more slender than I am) provided some valuable assistance in this step. My tv is on a slim mount on the wall, so it was a little bit difficult to get the 3.5mm plug all the way in.
0 Comments
And apparently, the one thing that I didn't try (but learned about AFTER I reset) might have helped. Click Yes to restart the system and enter WinPE mode. Insert the MSI Image Backup disk and a USB flash drive with sufficient capacity, and then select Backup in the WinPE menu. I had to actually sift through the settings in the Killer networking console, and disable them to see which was causing the problem. Might have worked!īut anyway, worst came to worst, I used BurnRecovery to make a bootable USB of the MSI factory image, and reset the OEM image. Just be advised that if you have a second storage drive, and choose the option to restore ONLY to the C: drive (meaning that you don't want the stuff on the extra drive wiped), then the image will install a separate partition as part of your primary drive. You will need to delete that extra partition on your primary drive, shift the over recovery partition around (because it will be wedged between them), and expand the C: partition. The radio transmits at 1,610.0 to 1,660.5 MHz and receives at. It provides secure and reliable two-way messaging at L-band frequencies, delivering data rates to 131 kb/s. The aim of the Act is to encourage people to walk or cycle for short journeys to access a workplace or educational establishment or to access health, leisure or other services or facilities and to ultimately make Wales a walking and cycling nation. The MT-2025 transceiver vehicle satellite transceiver is tested to MIL-STD-810F and MIL-STD-461F requirements and is a full-duplex system capable of supporting military GPS. The Integrated Network Map has been developed to meet our duties under the Active Travel Act which was passed by the Welsh Assembly in October 2013. The Integrated Network Map is a 15-year vision to improve infrastructure for walkers and cyclists across the County. Welsh Ministers have now approved Flintshire County Council’s Active Travel Integrated Network Map following a public consultation which was held between July and September in 2017. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |